Roof construction
1. The steel structure with glass wool felt along the vertical direction of the slot spread, for the veneer of glass wool felt, will have veneer side exposed in the indoor, so that the indoor beautiful, and have a good reflective effect. Set aside about 20 cm of rolled felt at the eaves of one side, fixed to the outermost purlin with special clamps or double-sided tape;
2. To ensure alignment and tensioning when laying glass wool blanket, lay glass wool blanket on the other eave with the same amount of 20 cm roll blanket, use special furniture or double-sided tape to fix it on the outermost purlin;
3. The two rolls of cotton are connected together by stapler binding on the veneer flapping edge;
4. Install the roof color steel plate, remove the special fixture on both sides of the eaves, and use the reserved 20 cm veneer to close the edge of the glass wool to achieve good moisture-proof effect;
Wall construction
1. The veneer faces the interior side, roll it from the eaves to the corner, fix the glass roll felt on the bottom purlin with double-sided tape, leave 20 cm more;
2. In the glass cotton felt over the top of the wall groove 20 cm will be cut off, fixed with double-sided tape;
3. The glass wool edge, install the wall color steel plate;
4. The horizontal connection between cotton and cotton is connected together by the stitching machine binding method on the veneer flying edge;
